Mounting NFS for the HPE Ezmeral Data Fabric to file system on a Cluster Node

You can automatically or manually mount NFS for the HPE Ezmeral Data Fabric to the file system on a cluster node.

NOTE The procedure works only on nodes where NFS service is installed.

Automatically Mount

Use this procedure to automatically mount NFS for the HPE Ezmeral Data Fabric to file system on the cluster my.cluster.com at the /mapr mount point.
  1. Set up the mount point by creating the directory.
    sudo mkdir /mapr
  2. Add the following line to /opt/mapr/conf/mapr_fstab: 
    <hostname>:/mapr /mapr hard,nolock
    NOTE The change to /opt/mapr/conf/mapr_fstab will not take effect until Warden is restarted.
    Every time your system is rebooted, the mount point is automatically re-established according to the mapr_fstab configuration file.

Manually Mount

Use this procedure to manually mount NFS for the HPE Ezmeral Data Fabric to file system on the cluster my.cluster.com at the /mapr mount point.
  1. Set up a mount point for a NFS for the HPE Ezmeral Data Fabric share. 
    sudo mkdir /mapr
  2. Mount the cluster via NFS for the HPE Ezmeral Data Fabric. 
    sudo mount -o hard,nolock usa-node01:/mapr /mapr
    NOTE When you mount manually from the command line, the mount point does not persist after a reboot.