Mounting NFS for the HPE Ezmeral Data Fabric to file system on a Cluster Node

You can automatically or manually mount NFS for the HPE Ezmeral Data Fabric to the file system on a cluster node.

Automatically Mount

Use this procedure to automatically mount NFS for the HPE Ezmeral Data Fabric to file system on the cluster my.cluster.com at the /mapr mount point.
  1. Set up the mount point by creating the directory.
    sudo mkdir /mapr
  2. Add the following line to /opt/mapr/conf/mapr_fstab: 
    <hostname>:/mapr /mapr hard,nolock
    NOTE The change to /opt/mapr/conf/mapr_fstab will not take effect until Warden is restarted.
    Every time your system is rebooted, the mount point is automatically re-established according to the mapr_fstab configuration file.

Manually Mount

Use this procedure to manually mount NFS for the HPE Ezmeral Data Fabric to file system on the cluster my.cluster.com at the /mapr mount point.
  1. Set up a mount point for a NFS for the HPE Ezmeral Data Fabric share. 
    sudo mkdir /mapr
  2. Mount the cluster via NFS for the HPE Ezmeral Data Fabric. 
    sudo mount -o hard,nolock usa-node01:/mapr /mapr
    NOTE When you mount manually from the command line, the mount point does not persist after a reboot.