Setting Whole Volume ACEs

Describes how to set ACE expressions when creating or modifying volumes.

You can set Access Control Expression (ACE)s at the time of volume creation using the volume create command and modify them at a later time using the volume modify command. When you run the command to set or modify ACEs, the command does the following:

  • Overwrites existing values with new values, if specified, for access types that were previously set.
  • Sets values for access types that have not yet been set, if specified.
  • Does not modify access types that were not specified with the command, whether they were previously set or are unset.

When you set whole volume ACEs, permissions on files and tables under that volume remain unchanged. Also, new files and tables in the volume do not inherit the whole volume ACEs of that volume. Instead, whole volume ACEs, if set, are used to determine volume level access to tables and files within the volume. To gain access to volume data, the user must have access at both the volume and file/table levels.

Whole Volume ACE Example

For example, suppose the following sequence of whole volume ACE settings for users u3 and u4 is as follows.

NOTE In the following illustration, default ACE values are shown in red.


As shown in the illustration above, in:

Step 1:

User u3 is granted permissions to read.

User u3: User u3 has permissions to read files and tables at the volume level and by default, user u3 has write permission (shown in red) at the volume level. However, for:
  • Files in the volume, file ACE or POSIX mode bits are used to determine read and write access for user u3.
  • Tables in the volume, table ACEs are used to determine read and write access for user u3.

User u4: User u4 cannot read files and tables within the volume because the ACE for the volume does not explicitly grant access to user u4. Although user u4 has write permission by default, user u4 cannot write to files/tables in the volume because user u4 does not have read permission.

Step 2:

User u3 is granted permissions to write.

User u3: User u3’s read access remains unchanged and although user u3 has permissions to write to files and tables, for:
  • Files in the volume, file ACE or POSIX mode bits are used to determine write access for user u3.
  • Tables in the volume, table ACEs are used to determine write access for user u3.

User u4: User u4 cannot write to files/tables in the volume.

Step 3

User u4 is granted read access.

User u3: User u3’s read and write access remains unchanged.

User u4: User u4 has permissions to read files and tables at the volume-level; however, for:
  • Files in the volume, file ACE or POSIX mode bits are used to determine read access for user u4.
  • Tables in the volume, table ACEs are used to determine read access for user u4.