Upgrading Impala
This section describes how to upgrade Impala without the MapR Installer.
IMPORTANT This component is deprecated. Hewlett Packard
Enterprise recommends using an alternate product. For more information, see Discontinued Ecosystem Components.
- Upgrade the
mapr-impala
package on all Impala nodes in the cluster:$ sudo yum update mapr-impala
- In
/opt/mapr/impala/impala-<version>/conf/env.sh
, complete the following steps:- Verify that the Statestore address is set to the address where you plan to run the
statestore
service.
IMPALA_STATE_STORE_HOST=<IP address hosting statestore>
- Change the Catalog service address to the address where you plan to run the catalog
service.
CATALOG_SERVICE_HOST=<IP address hosting catalog service>
Refer to Additional Impala Configuration Options for a list of other options that you can modify in
env.sh
.
- Verify that the Statestore address is set to the address where you plan to run the
statestore
service.
- Verify that
hive-site.xml
has the following property configured on all nodes:<property> <name>hive.metastore.uris</name> <value>thrift://<metastore_server_host>:9083</value> </property>
- To upgrade the statestore service, issue the following
command:
$ sudo yum update mapr-impala-statestore
- To upgrade the catalog service, issue the following
command:
$ sudo yum update mapr-impala-catalog
NOTE It is recommended (not required) that you install the catalog service on the same node as the statestore service. - To upgrade the impala server, issue the following
command:
$ sudo yum update mapr-impala-server
- Run
configure.sh
to refresh the node configuration./opt/mapr/server/configure.sh -R