Lists disk parameters.
Disk Fields
The following table shows the fields displayed in the output of the disk
list and disk listall commands. You can choose which fields (columns) to display and sort in
ascending or descending order by any single field.
- availablespace
- Terse Name: dsa
- Description: Disk space available, in MB.
- diskname
- Terse Name: n
- Description: Name of the disk or partition
- error
- Terse Name: err
- Description: Disk error message, in English. Only sent if status is
1.
NOTE This message is not translated.
- failuretime
- Terse Name: ft
- Description: Disk failure time, This field is applicable only for MapR disks. Only
sent if status is
1.
- firmwareversion
- Terse Name: fw
- Description: Firmware version
- fstype
- Terse Name: fs
- Description: File system type
- hostname
- Terse Name: hn
- Description: Hostname of the node that owns this disk/partition
- modelnum
- Terse Name: mn
- Description: The model number of the disk
- mount
- Terse Name: mt
-
Description: Disk mount status
0 = unmounted1 = mounted
- powerstatus
- Terse Name: pst
- Description: Disk power status:
0 = Active/idle (normal operation)1 = Standby (low power mode)2 = Sleeping (lowest power mode, drive is completely shut
down)
- serialnum
- Terse Name: sn
- Description: Serial number of the disk
- status
- Terse Name: st
- Description: Disk status:
0 = Good1 = Bad disk2 = Offline disk
- totalspace
- Terse Name: dst
- Description: Total disk space, in MB
- usedspace
- Terse Name: dsu
- Description: Disk space used, in MB
- vendor
- Terse Name: ven
- Description: Name of the disk vendor